1、This unloading method cannot be used when the fill factor of the conveyor is over 0.45.
當輸送機填充系數超過0.45時將不能采用這種卸料方法。

2、Invalid fill factor value specified. The value should be within 0 to 100.
指定的填充因子值無效。該值應在0到100之間。

3、Specify a fill factor when you want to fine-tune performance.
在需要精細調整性能時指定填充因子。

4、Invalid fill factor value specified. The value should be between 0 to 100.
指定的填充因子值無效。該值應該在0到100之間。

5、The fill factor is the percentage of free space allotted when a new index page is created.
填充因子是在創建新索引頁時分配的可用空間的百分比。

fill factor翻譯